Вид документа : Шифр издания : 53/M 43 Автор(ы) : Maydanik Yu. F., Dmitrin V. I., Pastukhov V. G. Заглавие : Compact cooler for electronics on the basis of a pulsating heat pipe Место публикации : Applied Thermal Engineering. - 2009. - Vol.29, №17-18. - С. 3511-3517 ББК : 53 Предметные рубрики: ФИЗИКА Ключевые слова (''Своб.индексиров.''): pulsating heat pipe--electronics cooling--heat load Аннотация: The paper presents the results of developing and investigating a compact cooler for electronics made on the basis of a closed loop pulsating heat pipe (CLPHP). The cooler is made of a copper tube 5.6 m long with OD of 2 mm and ID of 1.2 mm in the form a 3D spiral containing 17 turns. The device is equipped with a light copper radiator with a finning area of 1670 cm2, which was blown by an axial fan located inside the spiral. The thermal interface of the cooler situated in the heating zone is made of a copper plate with a thermocontact surface measuring 40 × 35 mm, which was in thermal contact with all the turns of the device. The cooler overall dimensions are 105 × 100 × 60 mm, its mass is 350 g. The operation of the cooler has been investigated with water, methanol and R141b as working fluids at a uniform and concentrated supply of a heat load in different heating modes. A reliable operation of the device has been demonstrated in the range of heat loads from 5 to 250 W. A minimum thermal resistance “heat source–ambient air” equal to 0.32 °C/W was attained with water and methanol as working fluids at a uniform heat load of 250 W. With a heat load concentrated on a section of the thermal interface limited by an area of 1 cm2, a minimum value of thermal resistance equal to 0.62 °C/W was attained at a heat load of 125 W when methanol was used as a working fluid Доп.точки доступа: Dmitrin, V. I.; Pastukhov, V. G.; Пастухов Владимир Григорьевич; Майданик Юрий Фольевич